The Industry Choice for Affordable, High Quality Equipment, Supplies and Service

Home >> Dental Sterilization >> Automatic Autoclaves >> Pelton & Crane Validator 10+

Pelton & Crane Validator 10+

This product is out of stock or no longer available!

Here are products by the same manufacturer: Pelton & Crane

Here are products in the same category: Automatic Autoclaves

Pelton & Crane Validator 10+

Product Information:

$2,498.00Call For Availability

Product Description:

Safety Features

The design of the Validator Plus autoclave incorporates several safty features for your protection.

  • Door Lock - Door can be opened only when internal pressure is at atmospheric pressure.
  • Safety Valve - The safety valve opens as backup protection to reduce chamber pressure in the event pressure exceeds 262 kPa.
  • Vent Valve - The vent valve will open if chamber pressure should exceed 241 kPa, and the P-2 alarm will display.
  • Overheat Protection - Chamber temperature is set so as not to exceed 159° C and has an additional overheat protection if temperature reaches 180° C.
  • Electrical Power Interruption - In case of an electrical power failure during the sterilization cycle, pressure in the chamber is automatically vented to the atmosphere.
  • Chamber Overfill Protection - The Validator features an electronic sensor to prevent the chamber from overfilling.

Technical Specifications

Exterior Dimensions 14" high x 24 5/8" deep x 19 1/4" wide (36 cm high x 62.5 cm deep x 49 cm wide)
Chamber Dimensions 9 7/8" (25 cm) inside diameter x 17 1/2" (44.5 cm) deep
Weight without Water in the Reservoir 84 lbs. (38kg)
Power Supply 100 - 120 Volt - 50/60 Hz
Nominal Current Consumption 16 Amperes
Maximum Power Consumption 1460 Watts
Environmental and Storage Limitations Optimum Operating Temperature range - 41° F (5° C) to 122° F (50°C)
Humidity - Less than 90%, non-condensing
Optimum Storage Temperature Range - -4° F (-20° C) to 140° F (60° C)
Unit is designed for normal dental office environment.